VEGA/S Mulcher

Condition: Brand New
Call Us: 03 5721 6002
  • Features
  • Options
  • Specifications
  • Brochure



  • Category 1 & 2 linkage headstock
  • 2 lower link pin positions
  • Slotted top link clevis for floating operation


  • 540 PTO rpm gearbox input
  • Gear box, driveline, body and rotor rated to 80 hp
  • Free wheel in gearbox so that on disengaging the PTO, the mulching rotor winds down without driving through the gear box and PTO drive shaft
  • The Rotor is driven by 4 belts (3 belts up to the 155 cm width model)
  • 140mm diameter rotor for strength


  • Rotor spins on self-aligning bearingswith high radial load capacity ideal for the forces created by drive belts and the mulching operation.
  • The bearing is mounted within the rotor with labyrinth protection resisting the entry of debris for longer life.
  • Internal bearings gives a flat end plate for mulching up close to trees and obstacles.


  • The cut-away drawing shows the combination of hammers and counter blades working together to produce an excellent mulching environment
  • Hammers operate at over 2000 rpm for ahigh tip speed to produce a fine mulch of woody prunings or grass alike
  • Double counter blades resist the flow of larger material allowing hammers to produce a finer mulch
  • Rear rake tines retains prunings within the mulcher chamber to produce a finer mulch

  • Twin plate construction produces box-section areas in the body forsuperb body stiffness and strength and lower noise
  • To reduce body dents that initiate rust and accelerate deterioration, the twin plates also provide an inner skin to take the hard impacts reducing outer skin dents

  • The hammer is forged and heat treated from high-grade steel and hardened
  • The hanging bolt is embedded into the hanging point for protection and to prevent spinning and unnecessary wear
  • The use of genuine Celli blades, hammers and bolts are essential forsafety, performance and protection of the mulcher

  • The openable rear door provides easy service access to check on hammer condition and to remove entangled debris


  • A large 194mm diameter rear roller with scraper provides mulcher height control
  • The body end plates are protected by a heavy duty skid
  • Skids provide primary protection of the body end plates and are not intended to be the means of height control
  • A rear roller (or optional wheels) provide cutting height control
  • The optional openable rear door is shown



  • Vineyards interrow grass cutting and mulching of prunings
  • General grass cutting and topping
  • Prunings up to 45mm
  • Typical vineyard mulching application


  • Openable rear door
  • Rear prunings rake tines
  • Rear semi-swivel wheel kits
  • Side-mounted hydraulic disk mower
  • Front-mounted hydraulic sweeper



VEGA/S 125 VEGA/S 150 VEGA/S 175 VEGA/S 200
Working Width (m) 1.25 1.50 1.75 2.00
Overall Width (m) 1.40 1.68 1.93 2.18
No. of Hammers 12 14 16 18
Weight (kg) 400 455 505 555
Tractor Power (hp) 35-60 40-70 50-70 55-70


Click to download a brochure

Please note that Australian specifications may vary to those shown on the manufacturer’s brochure and website. Follow this link to the manufacturer’s website (Celli)

Disclaimer: Specifications and features described on the website are subject to change without notice. All care has been taken to present accurate information, however, the company is not liable for unintended errors or omissions.